Pedplot

Primo plotter

Half-life estimate, not bloodwork or dosing advice. Disclaimer.

t½ 4.5dTmax 2d70% parent

To step a dose up, add another row of the same compound with a later start day. The chart is remaining active amount, not serum concentration.

Peaks, troughs, and half-life
Estimated remaining active mg. Washout continues after the last dose. Mixed IU and mg protocols are not summed.

Methenolone enanthate

Peak

336 mg

Trough

267 mg

Swing

21%

~Steady state

22.5d

~Washout

24.5d

Start from a protocol
Fills the form with a common stack. Edit the numbers after. Educational sketch, not a recommendation.
Saved locally
Stored in localStorage on this device. Reload a saved protocol from this list.

No saved protocols in this browser yet.

How to read this chart

Primobolan Depot. Enanthate ester of methenolone; often plotted next to testosterone at a similar schedule.

The default row models 200 mg as an intramuscular dose, twice a week (e3.5d), for 12 weeks.

Also called Methenolone enanthate, Primobolan, Primobolan Depot, Primo E, Primo Steroid.

The numbers

Half-life4.5d
Time to peak2d
Parent hormone70%
Default dose200 mg
Default frequencyTwice a week (E3.5D)
Default duration12 weeks

What the default curve does

On that default row the model counts 24 doses. Steady state is about day 22.5. Washout runs to about day 24.5. In the last interval the peak is 336 mg and the trough is 267 mg, a swing of 21%.

Parent hormone

About 70% of each milligram is parent hormone, so 100 mg of Methenolone enanthate leaves about 70.0 mg of Methenolone.

How often a dose is still there

A half-life of 4.5d means a dose is still present at the next one, so the line climbs and then levels off.

Closest comparison

Test E has a half-life of 4.5d against 4.5d on this page. Parent hormone is 72% there against 70% here.

An illustration already in the app

Test E 500 + Primo 400 plots 200 mg twice a week (e3.5d) for 16 weeks. It is an illustration already in the app, not a protocol to follow.

Open Test E 500 + Primo 400 in the plotter

Where the number comes from

Ester fraction ~0.70; injectable primobolan uses the enanthate ester (~4.5 d). How the model works.